Quantum Machinery HYDRAULIC LOCK PRESS

Hydraulic press for locks QUANTUM NARGESA PI85, with a fast and accurate perforation for the casing, handle and lock hole in a tube. It's a state-of-the-art novelty in the world of locks. Patented by Nargesa in 2006, this machine makes us the leaders in the manufacturing of this kind of machine. They fit 85% of locks of all trademarks and models.

TECHNICAL FEATURES

•  Normally, one operative has an average time between 30 - 45 minutes to make one whole operation for a casing, handle holes and the lock hole in a square or rectangular tube. With the PI85 Nargesa the time gets reduced to less than one minute. This is a machine for high production.

• The finish is perfect, with the proper tolerance to place the lock with no need to use a bezel. Thus the assembling time is minimum.

• Many companies that have bought this press for locks PI85, not only for their own use but also to sell the ready-to-be-used tubes to other companies.

• The tubes that can be used with the machine are 35x35, 40x40, 40x50, 40x60, 40x70, 40x80, 50x50, 50x60, 50x70 and 50x80.

• Tube thickness can be 1,5mm and 2mm. No matter the material, it can either punch normal steel, galvanized steel or stainless steel.

• It's important to bear in mind the casing must be always made in the side of 35, 40 or 50mm.

• The perforation of the lock hole and the handle could be combined, it means we can punch a tube with lock and handle on both ends,  as we can as well make either the handle or the lock in the other.

• The casing length is adjustable as it is as well the entrance of the lock. It ranges from 18mm to 37mm.